HP StorageWorks 1/8 - Setting the Date and Time; Configuration: Password Page; Setting Date;Time

NOTE:
You must set the administrator password with the OCP before you can access administrator functionality
in the RMI. See “Changing the administrator password (Configuration > Change Admin
Password)” on page 90.
Figure 42 Configuration: Password page
.
You may change the:
• Password — The password is exactly eight numbers, each from 0 to 9.
• Password Time Out — The number of minutes that the current administrator login session will remain
logged in without user interaction.
Setting the date and time
Use the Configuration: Date/Time page to set the date and time.
NOTE:
The device does not adjust its time to daylight saving time; the time must be adjusted manually.
Operating the Tape Autoloader70