10. Install the OCP NIC 3.0 adapter:
a. Rotate the locking pin to the open (vertical) position (callout 1).
b. Slide the adapter into the bay until it clicks into place (callout 2).
Make sure that the adapter is seated firmly in the slot.
c. Rotate the locking pin to the close (horizontal) position (callout 3).
11. Install the secondary riser cage.
12. Install the access panel .
13. Install the server into the rack .
14. Connect all peripheral cables to the server.
15. Connect the power cords:
a. Connect each power cord to the server.
To Next Page
Loading...
