13. Install the 2 SFF NVMe drive backplane onto the 2 SFF drive cage.
14. Install the 2 SFF side-by-side drive cage assembly.
15. If you intend to connect the 2 SFF drive backplane to a storage controller option, install it now:
Type-p storage controller
16. Connect the following cables to the 2 SFF drive backplane:
Drive power cable
Storage controller cable
17. Install the drives .
18. Install the fan wall.
19. Install the fans.
20. Install the middle cover .
21. Install the access panel .
22. Install the server into the rack .
23. Connect all peripheral cables to the server.
24. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
To Next Page
Loading...
