HSD ES919 NC - Identification of Manufacturer and Part

______HSD Technological equipment for Automation _____________________________________
5801H0017 Rev. 02 _________________________________________________________ 10/98
6.2 IDENTIFICATION OF MANUFACTURER AND PART
The data label shown below is the only form of electro-spindle identification recognised by the
manufacturer, and must be kept in its original legible condition. Figure 6.1 shows the electro-
spindle data label, while Figure 6.2 shows its location on the electro-spindle (Position 2).
1
Commercial part name and HSD code
2
CE label
3
“CERAMIC” (models with ceramic bearings only)
4
Serial number
5
Description of the tool holder cone
6
Commercial name of electro-spindle
7
Description of air inlets
8
HSD code for stator group
Figure 6.1 The CE label
NOTE:
Some of the symbols shown here may not be
present on your particular electro-spindle.
6
5
4
3
7
8
2
1
Figure 6.2 Location of the CE label and other symbols on the electro-spindle