HSD ES919 NC - Cooling Circuit; Cooler Specifications

______HSD Technological equipment for Automation _____________________________________
5801H0017 Rev. 02 _________________________________________________________ 45/98
9.5 COOLING CIRCUIT
Liquid-cooled models must be connected to a coolant circuit to dissipate the heat generated during
machining. Coolant must be: water with 10% ethylene glycol.
Out
In
CONNECTION DESCRIPTION THREAD
Out
Coolant circuit outlet G 1/4”
In
Coolant circuit inlet G 1/4”
Hose internal diameter (at least) 8 mm ( 5/16 in. - 315 mils )
9.5.1 Cooler specifications
Cooling capacity 1600 W
Minimum delivery 3 litres/minute ( 0.11 cfm )
Coolant type H
2
O + 10% ethylene glycol
Cooler set temperature +25°C ( +77°F )