______HSD Technological equipment for Automation _____________________________________
5801H0017 Rev. 02 _________________________________________________________ 97/98
§ 16 DISPOSING OF THE ELECTRO-SPINDLE
RESIDUAL RISKS:
THE DRAW BAR SPRING IS PRE-LOADED WITH A FORCE
OF HUNDREDS OF KILOGRAMS: IN HSK MODELS IN
PARTICULAR THE DRAW BAR CAN BE VIOLENTLY
EXPELLED FROM THE UNIT, WITH SERIOUS RISK OF
INJURY, IF THE ELECTRO-SPINDLE IS DISASSEMBLED BY
UNTRAINED PERSONNEL.
TAKE GREAT CARE AND IN CASE OF DOUBT, CONTACT
THE HSD TECHNICAL ASSISTANCE SERVICE.
At the end of the electro-spindle's working life it is the customer’s responsibility to dispose of it
correctly.
First of all, clean the unit and separate the various components into mechanical and electrical
parts. Then separate the component parts according to type of material: electric motors (copper
windings), metal parts (body, etc.), plastic parts, etc.. Dispose of the various materials in
compliance with the laws and regulations applicable in the country where the electro-spindle has
been installed.
To Next Page
Loading...