______HSD Technological equipment for Automation _____________________________________
5801H0017 Rev. 02 _________________________________________________________ 55/98
11.4.3 General safety precautions for tool holders
THE RIGHT CHOICE OF TOOL HOLDER IS ESSENTIAL FOR SAFE
MACHINING. CAREFULLY FOLLOW THE INSTRUCTIONS GIVEN IN
SECTIONS 11.4.1 (ISO 30) AND 11.4.2 (HSK F63).
KEEP THE CONICAL SURFACES OF THE TOOL HOLDER AND ITS
HOUSING IN THE SPINDLE SHAFT PERFECTLY CLEAN TO ENSURE
A SAFE GRIP (SEE SECTION 12.1 ).
DURING MACHINING, TAKE GREAT CARE TO AVOID CONTACT
BETWEEN NON-CUTTING ROTATING PARTS AND THE WORK.
DIRT MUST NOT BE ALLOWED TO ENTER THE CONICAL HOUSING.
CLOSE IT WITH A SUITABLE PLUG OR A SPARE TOOL HOLDER.
AT THE END OF THE WORKING DAY, ALWAYS REMOVE THE TOOL
HOLDER FROM THE SPINDLE, TO PREVENT IT FROM STICKING.
PROTECT OR COVER THE SPINDLE NOSE AGAINST
CONTAMINATION.
To Next Page
Loading...