______HSD Technological equipment for Automation _____________________________________
5801H0017 Rev. 02 _________________________________________________________ 95/98
The tool holder is not balanced
Choose a tool holder in
accordance with sections 11.4.1
(ISO 30), 11.4.2 (HSK) and
11.4.3 (all).
The tool is not balanced
Choose a tool in accordance
with sections 11.4.4 and 11.5 .
There is dirt or foreign bodies
between the tool holder and the
spindle shaft housing
Remove any large foreign
bodies and clean the tool holder
cone and spindle housing as
instructed in section 12.1.2 .
The inverter setup is incorrect
Check the specifications for your
model of electro-spindle on its
data label and in section § 7.
The machining is taking up too
much power
Reduce the machining power
requirements.
The fixing bolts are loose Tighten the fixing bolts.
The electro-spindle vibrates
The bearings are worn or
damaged
Replace the spindle shaft kit.
The bearings are noisy
The bearings are worn or
damaged
Replace the spindle shaft kit.
To Next Page
Loading...