[SwitchD-rrpp-domain-region1] ring 1 enable
[SwitchD-rrpp-domain-region1] quit
Step 6 Enable RRPP.
After configuring an RRPP ring, enable RRPP on each node on the ring. Then the RRPP ring
can be activated.
# Enable RRPP on Switch A.
[SwitchA] rrpp enable
# Enable RRPP on Switch B.
[SwitchB] rrpp enable
# Enable RRPP on Switch C.
[SwitchC] rrpp enable
# Enable RRPP on Switch E.
[SwitchE] rrpp enable
# Enable RRPP on Switch D.
[SwitchD] rrpp enable
Step 7 Verify the configuration.
After the configurations are complete and network become stable, run the following commands
to verify the configuration. Take the tangent point Switch C for example.
l Run the display rrpp brief command on Switch C. The following information is displayed:
[SwitchC] display rrpp brief
Abbreviations for Switch Node Mode :
M - Master , T - Transit , E - Edge , A - Assistant-Edge
RRPP Protocol Status: Enable
RRPP Working Mode: HW
RRPP Linkup Delay Timer: 0 sec (0 sec default).
Number of RRPP Domains: 2
Domain Index : 1
Control VLAN : major 10 sub 11
Protected VLAN : Reference Instance 1
Hello Timer : 2 sec(default is 1 sec) Fail Timer : 7 sec(default is 6 sec)
Ring Ring Node Primary/Common Secondary/Edge Is
ID Level Mode Port Port Enabled
---------------------------------------------------------------------------
1 0 T XGigabitEthernet0/0/1 XGigabitEthernet0/0/2 Yes
Domain Index : 2
Control VLAN : major 20 sub 21
Protected VLAN : Reference Instance 2
Hello Timer : 3 sec(default is 1 sec) Fail Timer : 10 sec(default is 6 sec)
Ring Ring Node Primary/Common Secondary/Edge Is
ID Level Mode Port Port Enabled
---------------------------------------------------------------------------
2 0 T XGigabitEthernet0/0/3 XGigabitEthernet0/0/4 Yes
You can find that RRPP is enabled on Switch C. The main control VLAN of domain 1 is
VLAN 10 and the sub control VLAN is VLAN 11. Switch C is the master node of ring 1,
with XGE 0/0/1 as the primary interface and XGE 0/0/2 as the secondary interface.
The main control VLAN of domain 2 is VLAN 20, and the sub control VLAN is VLAN 21.
Switch C is a transit node on ring 2, with XGE 0/0/3 as the primary interface and XGE 0/0/4
as the secondary interface.
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 3 RRPP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
93
To Next Page
Loading...
