EasyManua.ls Logo

Huawei Quidway S6700 series - 6.3 Configuring the VRRP Backup Group

Huawei Quidway S6700 series
295 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Step 2 Set IP addresses of VLANIF 13 interfaces so that Switch A can communicate with Switch B at
Layer 3.
# Configure Switch A.
[SwitchA] interface vlanif13
[SwitchA-Vlanif13] ip address 10.1.1.5 24
[SwitchA-Vlanif13] quit
# Configure Switch B.
[SwitchB] interface vlanif13
[SwitchB-Vlanif13] ip address 10.1.1.6 24
[SwitchB-Vlanif13] quit
After the configuration, run the display interface vlanif command on Switch A or Switch B.
You can view that the status of VLANIF 13 is Up.
[SwitchA] display interface vlanif 13
Vlanif13 current state : UP
Line protocol current state : UP
Description:HUAWEI, Quidway Series, Vlanif13 Interface
Route Port,The Maximum Transmit Unit is 1500
Internet protocol processing : disabled
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 0018-827d-75f5
Last 300 seconds input rate 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes
Output: 0 packets, 0 bytes
Input bandwidth utilization : --
Output bandwidth utilization : --
Step 3 Configure single-hop BFD on Switch A.
# Enable BFD on Switch A.
[SwitchA] bfd
[SwitchA-bfd] quit
# Create a BFD session on SwitchA.
[SwitchA] bfd atob bind peer-ip 10.1.1.6 interface vlanif 13
[SwitchA-bfd-session-atob] discriminator local 1
[SwitchA-bfd-session-atob] discriminator remote 2
[SwitchA-bfd-session-atob] commit
[SwitchA-bfd-session-atob] quit
Step 4 Configure single-hop BFD on Switch B.
# Enable BFD on Switch B.
<Quidway> system-view
[Quidway] sysname SwitchB
[SwitchB] bfd
[SwitchB-bfd] quit
# Create a BFD session on Switch B.
[SwitchB] bfd btoa bind peer-ip 10.1.1.5 interface vlanif 13
[SwitchB-bfd-session-btoa] discriminator local 2
[SwitchB-bfd-session-btoa] discriminator remote 1
[SwitchB-bfd-session-btoa] commit
[SwitchB-bfd-session-btoa] quit
Step 5 Verify the configuration.
After the configuration, run the display bfd session command on Switch A and Switch B. You
can view that the single-hop BFD session is set up and the status is Up.
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 5 BFD Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
207

Table of Contents

Related product manuals