Huawei RH2288H V3 - Removing an Nvme Pcie SSD; Installing an Nvme Pcie SSD; Removing a PSU; Removing an AC PSU

Figure 7-9 Installing a drive
Step 5 Ensure that the ejector lever is fastened to the chassis beam, and then close it to
completely insert the drive into the slot. See (2) in Figure 7-9.
Observe the drive indicators to check the drive operating status. For details about
the indicators, see 2.4 Indicators and Buttons.
Step 6 If the server is equipped with a front bezel, install the bezel after installing the
front drive. For details, see 7.4 (Optional) Installing the Front Bezel.
Step 7 After verifying drive status,
congure RAID properties based on actual service
requirements. For details, see
Huawei V2 and V3 Server RAID Controller Card
User Guide .
----End
7.7 Removing an NVMe PCIe SSD
For details, see "Removing an ES3000 V3" in
ES3000 V3 NVMe PCIe SSD User
Guide
.
7.8 Installing an NVMe PCIe SSD
For details, see "Installing ES3000 V3" in
ES3000 V3 NVMe PCIe SSD User Guide .
7.9 Removing a PSU
7.9.1 Removing an AC PSU
Remove an AC PSU before replacing it with a new one.
When two PSUs are congured, remove one PSU without powering o the
RH2288H V3 if the other PSU is operating properly and its power rating is greater
than or equal to the power rating of the RH2288H V3.
RH2288H V3 Server
User Guide 7 Replacing Parts
Issue 46 (2022-12-28) Copyright © Huawei Technologies Co., Ltd. 157