Figure 7-132 Installing the SD card board
2. Tighten the two screws. See (2) in Figure 7-132.
Step 8 Install the chassis cover. For details, see 7.12 Installing the Chassis Cover.
Step 9 Install the RH2288H V3. For details, see 3.4 Installing the Server.
Step 10 Connect all external cables such as power and network cables. For details, see 3.5
Connecting External Cables.
Step 11 Power on the RH2288H V3. For details, see 4.1 Powering On the Server.
Step 12 Check the SD card status.
● Log in to the iBMC WebUI, choose Information > System Info, select the
Other Devices tab, and check the SD card status. For details, see
Huawei
Rack Server iBMC User Guide
.
● If one of the two SD cards is replaced, view the iBMC event log information to
check whether the SD card rebuild is complete.
In the iBMC event log, "Data rebuild starts at SD card
N
" is logged after the
server is powered on.
N
indicates the SD card slot number. "Data rebuild stops
at SD card
N
indicates that the SD card rebuild is complete.
If the SD card is in abnormal status, contact Huawei technical support.
----End
7.53 Removing an SD Card Board
Remove a SD card board before replacing it with a new one.
RH2288H V3 Server
User Guide 7 Replacing Parts
Issue 46 (2022-12-28) Copyright © Huawei Technologies Co., Ltd. 266
To Next Page
Loading...
