Huawei RH2288H V3 - Removing the Internal USB Flash Drive

Step 8 Use a Phillips screwdriver to tighten the screws. See step (2) in Figure 7-55.
NO TE
If fan modules have been installed, remove them and the fan support before tightening the
screws.
Step 9 Connect the cables from the DVD drive to the mainboard and the front hard disk
backplane. For details, see 2.7 Internal Cabling.
Step 10 Install the fan module brackets in the chassis. See Figure 7-56.
Figure 7-56 Installing fan module brackets
Step 11 Install the fan modules. For details, see 7.16 Installing a Fan Module.
Step 12 Install the air duct. For details, see 7.14 Installing the Air Duct.
Step 13 Install the chassis cover. For details, see 7.12 Installing the Chassis Cover.
Step 14 Install the RH2288H V3. For details, see 3.4 Installing the Server.
Step 15 Connect all external cables such as power and network cables. For details, see 3.5
Connecting External Cables.
Step 16 Power on the RH2288H V3. For details, see 4.1 Powering On the Server.
----End
7.27 Removing the Internal USB Flash Drive
Remove the USB
ash drive before replacing it with a new one.
RH2288H V3 Server
User Guide 7 Replacing Parts
Issue 46 (2022-12-28) Copyright © Huawei Technologies Co., Ltd. 197