Figure 7-60 Installing the USB ash drive (USB 3.0 port for the service system)
Step 5 Install the chassis cover. For details, see 7.12 Installing the Chassis Cover.
Step 6 Install the RH2288H V3. For details, see 3.4 Installing the Server.
Step 7 Connect all external cables such as power and network cables. For details, see 3.5
Connecting External Cables.
Step 8 Power on the RH2288H V3. For details, see 4.1 Powering On the Server.
----End
7.29 Removing the System Battery
Remove the system battery before replacing it with a new one.
Procedure
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Determine the cabinet number and chassis number of the server, and label its
panel to prevent misoperations.
Step 3 Power
o the RH2288H V3. For details, see 4.2 Powering O the Server.
Step 4 Remove all external cables such as power and network cables.
Step 5 Remove the RH2288H V3 and put it on an ESD desktop. For details, see 3.6
Removing the Server.
RH2288H V3 Server
User Guide 7 Replacing Parts
Issue 46 (2022-12-28) Copyright © Huawei Technologies Co., Ltd. 201
To Next Page
Loading...
