Huawei RH2288H V3 - Logging in to the Server over a Network Port Using Putty

Step 8 Click Open.
The PuTTY window is displayed.
Step 9 Enter the user name and password.
If the login is successful, the server host name is displayed on the left of the
prompt.
----End
9.6 Logging In to the Server over a Network Port Using
PuTTY
Use PuTTY to remotely log in to the server over a local area network (LAN).
Ensure that the following requirements are met:
● The local PC is connected to the management network port of the server
through a network cable.
● IP address of the server.
● User name and password for logging in to the server.
Procedure
Step 1 Download the latest version of PuTTY from the chiark website, and install PuTTY
on the local PC.
NO TE
Use the latest version of PuTTY, otherwise you may fail to log in to the server.
Step 2 Connect the local PC to the iBMC management network port on the server by
using a network cable.
Step 3 Set an IP address and a subnet mask or add route information for the PC to
communicate with the server.
Step 4 On the PC CLI, run the following command to check whether the server is
reachable:
Ping
Server IP address
Step 5 Double-click PuTTY.exe.
The PuTTY
Conguration window is displayed, as shown in Figure 9-8.
RH2288H V3 Server
User Guide 9 Common Operations
Issue 46 (2022-12-28) Copyright © Huawei Technologies Co., Ltd. 313