Huawei RH2288H V3 - Removing an SD Card

Figure 7-126 Installing a SATADOM
Step 6 Install the chassis cover. For details, see 7.12 Installing the Chassis Cover.
Step 7 Install the RH2288H V3. For details, see 3.4 Installing the Server.
Step 8 Connect all external cables such as power and network cables. For details, see 3.5
Connecting External Cables.
Step 9 Power on the RH2288H V3. For details, see 4.1 Powering On the Server.
----End
Verication
1. Start the server. When the BIOS startup screen is displayed, press Delete to
start the BIOS Setup Utility.
2. Enter the BIOS password when prompted.
3. Choose Advanced > PCH SATA
Conguration and press Enter.
Check the component information.
SATADOM 1 and SATADOM 2 correspond to Serial ATA Port 4 and Serial
ATA Port 5 respectively.
7.51 Removing an SD Card
Remove an SD card before replacing it with a new one.
Remove SD cards based on actual situation. Back up important data on the SD
card before replacing it.
● If the server is
congured with only one SD card, replace the SD card board
with the spare part (BOM: 02311JDU). If the SD card is installed with the OS,
install the OS on the newly installed SD card.
RH2288H V3 Server
User Guide 7 Replacing Parts
Issue 46 (2022-12-28) Copyright © Huawei Technologies Co., Ltd. 260