Figure 3-19 Connecting an SFP+ cable
Step 6 Check that the new cable is properly connected.
Power on the device, and ping the IP address of the peer device connected over
the new cable. If the peer device cannot be pinged, check that the cable is intact
or the connector is securely connected.
Step 7 Bind the new optical cable.
Bind the new optical cable in the same way as existing optical cables. You can also
remove all cable ties and bind all of the optical cables again if necessary.
----End
3.5.4 Connecting a 56G IB Cable
If a 56G IB cable is to be replaced, ensure that the new cable is of the same model
as the one to be replaced or is compatible with the server.
The following tools are available:
● Phillips screwdriver: used to tighten screws
● ESD wrist strap or ESD gloves: used to prevent ESD damage
Procedure
Step 1 Check the model of the new network.
Step 2 Number the new cable.
● The new cable must have the same number as the old one.
● Use the same type of labels for optical cables. Record the name and number
of the local device to be connected on one side of an optical cable and those
of the peer device on the other side. Attach a label 2 cm (0.79 in.) away from
the end of a network cable.
RH2288H V3 Server
User Guide 3 Installing and Removing the RH2288H V3
Issue 46 (2022-12-28) Copyright © Huawei Technologies Co., Ltd. 100
To Next Page
Loading...
