Indicator State
PSU indicator ● Steady green: Both the active output
and the standby output are normal.
● Blinking green at 1 Hz:
– The input is normal, but the PSU
stops the output due to PSON or
Present#.
– The input is overvoltage or
undervoltage.
● Steady orange: The input is normal, but
no output is supplied due to overheat
protection, overcurrent protection, short
circuit protection, output overvoltage
protection, or some component failures.
●
O:
– There is no power supply to the PSU.
– No active or standby output is
supplied, and the PSU is faulty. For
example, the input is overvoltage or
undervoltage, the PSU has no output,
or the PSU is not detected.
Drive activity indicator
● O: The drive is not detected or is
faulty.
● Blinking green: Data is being read from
or written to the drive, or synchronized
between drives.
● Steady green: The drive is inactive.
Drive fault indicator ● O: The drive is working properly.
● Blinking yellow: The drive is located, or
RAID is building rebuilt.
● Steady yellow: The drive is faulty, or a
drive member drive in the RAID array is
faulty.
NOTE
If the fault indicator is steady yellow, run related
commands to check the RAID status to
determine whether the RAID array status is
abnormal or whether the drive is faulty. For
details about command description, see
Huawei
V2 and V3 Server RAID Controller Card User
Guide
.
Table 2-8 describes the indicators of LANs on motherboard (FlexIO cards) on the
RH2288H V3 rear panel.
RH2288H V3 Server
User Guide 2 Overview
Issue 46 (2022-12-28) Copyright © Huawei Technologies Co., Ltd. 24
To Next Page
Loading...
