IBM System/360 20 - 118

r I -.-- -,
IColumn IContents 1 Indication I
r------+--------~I------- ~
I 1 Iblank I read or feed error I
I 1 I -t
1 11 I punch error 1
I )--------+----------------------------------------;1
) 12 1 read-format error, primary feed I
1 J 1 -----.
1 )3 1 read-format error, secondary feed 1
1 1----+ 1
I 14 1 punch-format error, primary feed 1
1 I --+-I ----- -t
1 I~ 1 punch-format error, secondary feed 1
I ) ------_+__ 1
1 16 I punch in EOF card, primary feed I
1 J 'I -t
1 17 I punch in EOF card, secondary feed 1
I- 1 --+- ~
1 2 Iblank 1 I
}-- I 1 -t
1 3
1
11 I error occurred during operation in primary I
1 I 1
feed 1
I 1 I -t
1 12 1 error occurred during operation in secondary 1
I 1 1 feed I
}-- 1 -I1r--.-.-- ---J
1 4 Iblank 1 1
l----+------+ I
1 52 1* I the hopper of orlgln and the stacker for the I
1 I I
card located at the pre-print station or at 1
1
lithe punch station when the halt occurred 1
I-- I -+-- -t
1 6
2
1* 1 the hopper of origin and the stacker for the I
) I I card located at the print station when the 1
1
1 1 halt occurred 1
l----t -11-- ----------------1
I 7 1* I the hopper of origin and the stacker for the I
I 1 I
last card stacked I
l- 1 -+- I
I 8 1* I the hopper of origin and the stacker for the 1
1 I 1
next-to-Iast card stacked 1
I-- 1 -+ I
1 9 JO or 2 orl number of "run-out" cards to be returned to I
1
13 or 4 I the primary hopper 1
l- 1 +----------------------------tJ
I 10 10 or 1 or) number of "run-out" cards to be returned to 1
1
12 or 3 1 the secondary hopper 1
.. 1 -+1--- ~
I*blank no card located in this position 1
1
12-0-9-n from primary hopper to stacker n 1
I
12-8-n from secondary hopper to stacker n J
J (n may be anyone of the digits 1 through 5) I
L J
1 For output files only (additional 12-punch in column 3): If the Feed-Check light was
on when halt code 0201 was displayed because a card did not properly register at the
punch station, punching was suppressed. In this case, check which feed was involved
and increase by 1 the number of cards to be returned to the corresponding hopper.
2 Normally, either column 5 or column 6 contains information. If both columns contain
information, no accurate restart procedures can be guaranteed.
Figure 49. Format of the Information Card Punched by the 2560 During Restart 34
118 System/360 Model 20 TPS Operating Procedures