IBM System/360 20 - 130

r--- i T i,
I Code I Cause IRestart IRef.No.1
I ESTR I I I I
t-- I --------+ I-J
I 05C1 ICondition code = 3; Xle instruction rejected IFollow procedure I 63 I
I I
(BSCA) 163 I I
l-- I +----------------+----1
I 0581 10PEN macro not issued or another initial IPress START on 53
I Imacro issued before transmission is finished ICPU to discon-
I I (BSCA) I tinue the jo t
~ I ~
I 0582 IA non-initial macro has been issued withcut I
I
Ithe preceding initial macro Q£ (in CCNFIG= I
I
lSW) connection not established (BSCA) I
~ I -t
I 0583 I Condition code = 1 after an executicn try I
I I
(in CONFIG=SW) Q£ condition code = 3 and I
I
Isense b}'te not set to X'4C' (ESCA) I
I-- I -t
I 0584 ITwo WRITE RVI macros issued immediately I
I
lafter each other or two RVI sequences I
I I
received in succession (BSCA) I
~------+ -J
I 0585 I Previous macro not completed (ESCA) I
J-- I -t
I 0586 IA WRITE has teen issued immediately after I
I
la READ receiving a message which did not I
I I
end with ETX (MODE=TAT only) (BSCA) I
J-------+ -J
I 0587 IA WRITE has been issued immediately after a I
I IWRITE
which resulted in a message resFcnse I
I I
(MODE = TAT only) (BSCA) I
r- I ~
I 0588 IInvalid third operand in macro (BSCA) I
J----------+ -J
I 058A INumber of leading graphic characters greater I
I I
than 7 .Q~ (in CONFIG=SW only) the nurrber of I
I
lID characters is greater than 15 I
J------+_ -J
I 058B INot enough space in CIOAREA for the expected I
I I
message (ESCA) I
J------_+_ -J
I 058C IErroneous or missing start-of-message se- I
I
Iguence in outgoing message (BSCA) I
~------+ -J
I 058D IErroneous or missing end-of-message sequence I
I
lin outgoing message g~ given message length I
I
Idoes not correspond to real message length I
I I
(ESCA) I
J------+------------------------------------t
I 05SE IThe user-defined CIOAREA is equal tc or I
I
Iless than 0 bytes or exceeds 4095 bytes I
I I
(ESCA) I
I I -J
I 0590 I Variable-length records, transparency, and I
I
lITE used concurrently (BSCA) I
I I -J
I 0593 IABORT requested issued when another ABORT I
I
I request has already teen catalcged (ESCA) I
, I -J
I 0595 IThe byte count for the telephone numteL I
I I
to be used by A UTOCALL is C (ESCA) I
l I I --1.. _____ --1
130 System/360 Model 20 TPS Operating Prccedures