IBM System/360 20 - 152

r ----------------.,--- ~----___,
I Code ICause I Bestart IBef.No.1
I ESTB I I I I
t-----+ ,----------~I -r----1
I 1B72 IControl statement has been encountered I Operator choice: I I
I ,while reading a macro definition cn la) Press START on CPU to I 53 I
I
I SYSI PT. I discon tin ue the jo 1;. I I
I I
11::) Enter FF into location CE I I
I I I
and press STABT on CPU to I I
I I I
continue processing. (T he I I
I
I I control statement is ignoredl I
I I I
and the macro definition is I I
I I I
processed.) I I
J-- I + I ~
I 1879 INo device assigned to SYSBDR. IPress START on CPU to 53
I I Idiscontinue the job.
J-- I -J
I 187A IImproper SYSOPT assignment: I
I I
a) no device assigned, I
lib) device assigned is not a tape drive, I
I
Ic) tape characteristics specification I
I I
for 7-track drive is not "data I
) I converter on". I
J-- -+1---- -J
I 1B7B IImproper SYSOOO assignment: I
I
la) no device assigned, I
lib) device assigned is net a tape drive, I
I Ic)
tape characteristics specification I
I I
for 7-·track drive is not "data I
I I
converter on". I
~ I -J
I 1B7C IImproper SYSIPT assignment: I
I I
a) no device assigned, I
lib) 7-track drive assigned, and tape I
I I
characteristics specification is not I
I
J "data converter on". I
t-----+------· ~
I 1B7D ISYSOPT has been assigned the same drive I
I I
as SYSRES. I
1-------+----- ~
I 187E ISYSOOO has been assigned the same drive I
I
las SYSRES or SYSOPT. I
t----t_ 1
I 1B7F 15YSIPT has been assigned the same drive I
I
las SYSRES, or SYSOPT, or 5YSOOO. I
1-----+ -f
I 1880 IThe printer has not been assigned to I
I I SYSLST. I I
;.------+ ---f--------------------+-----1
I 1881 IName field of control statement I Correct the statement 52
I Icontains improper specification. land continue processing.
t I J
I 1882 IControl statement contains invalid I
I
loperation code, or does not contain I
I
lany operation code. I
J-- I --J
I 1B83 IDSPLY control statement contains invalidl
I I operand (s) • I
J-- I -J
I 1884 IColumn 72 of control statement is not I
1 I blank. I
J-- I +
I 1885 IDirectory entry for Job Control has not IPress STABT on CPU to
I Ibeen found at beginning of library. Idiscontinue the job. (System
I I Itape is damaged or incorrect.)
L __ . __ .L ________ •
I
152 System/360 Model 20 TPS Operating Procedures
53
1
I
I
I
.L ____ .-J