IBM System/360 20 User Manual

r-,
the job must be discontinued (after
communicating with the operator of the
remote terminal) •
1641
Operator choice:
L--~ a) Follow the appropriate procedure as
indicated for halt code 02D2.
...--,
b) Follow the appropriate procedure as
indicated for halt code 02D2, but
enter a value other than 00 into
location CE before pressing the
start key on the CPU console. The
cards will then not be read (i.e.,
checked for "all blanks") before
they are punched.
1651 Operator choice:
L~ a) Follow the appropriate procedure as
indicated for halt code 02DJ.
...--,
b) Follow the appropriate procedure as
indicated for halt code 02D3, but
enter a value other than 00 into
location CE before pressing the
Start key on the CPU console. The
cards will then not be read (i.e.,
che cked for "all blanks tI) before
they are punched.
1661 Operator choice:
L __ ~ a) Follow the appropriate procedure as
indicated for halt code 02D4.
...--,
b) Follow the appropriate procedure as
indicated for halt code C2D4, but
enter a value other ihan 00 into
location CE before pressing the
Start key on the CPU console. No
more cards will then be punched
during the job.
1671 Operator choice:
L __ ~ a) Follow the appropriate procedure as
indicated for halt code 02D5.
b) Follow the appropriate procedure as
r--,
indicated for halt code 02t5, but
enter a value other than CO into
location CE before pressing the
start key on the CPU console. No
more cards will then be punched
during the jo!:.
1681 Operator choice:
L--~ a) Follow the appropriate procedure as
indicated for halt code 03D4.
...--,
b) Follow the appropriate procedure as
indicated for halt code 03D4, but
enter a value other than 00 into
location CE before pressing the
start key on the CPU console. No
more cards will then be punched
during the jot •
1691
Operator choice:
L __ J a) Press the Start key on the CPU con-
sole. The line will be reprinted.
r--,
b) Enter FF into location CE and press
the start key on the CPU console.
The line will not be reprinted.
c) Enter a value other than 00 or FF
into location CE and press the
start key on the CPU console. Any
misprinted line will now be
reprinted once without a halt
occurring before reprinting.
Reprinted lines will be marked.
1701 a} Press the Start key on the CPU
L--~ console to continue processing.
The card that caused the halt is
selected to a separate stacker.
b) Enter a value other than CO into
location CE and press the Start key
on the CPU console. Depending on
the type of error (read check or
punch check), no more cards will be
read (i.e., checked for "all
blanks") or punched, respectively.
Programmed-Halt Displays and Restart Procedures 125

IBM System/360 20 Specifications

General

Brand	IBM
Model	System/360 20
Category	Storage
Language	English