IBM System/360 20 User Manual

Figure 16 shows the arrangement of input
for the building of a tape-resident system.
ERROR HALTS
A number of programmed halts may occur dur-
ing the loading and execution of the Load
System Tape program. The halt codes dis-
played and the appropriate restart proce-
dures are described in the section
g£Q.9.~i!l!! meg - H al t D i~.E1Ey'§_i!n d _J!~§ t a £1
P r Q£.e d 'y£g§ •
II END
~- --=-=--='::=:.JI
(' ASSGN andlor CONFG : :
"
"
I J
__ J.
DESCRIPTICN CF OUTPUT
The outFut of the Load System Tape program
is an o?eratle tape-resident system on the
tape mounted on the drive assigned to
SYSCP'I.
liote~ The system tape should be
file-protected.
II END
- --,
/
/
L __ _
- ----7
Cord Job Control-Program
Phose 03
Job Control Statements
r Job Con"o' P,09"''''
Phases 00, 01, 02
SYSRDR
/
/
/
/
/
L __ _
used if Job Control
functions
are required
/
/
/
/
SYSIPT
Note: SYSRDR and SYSIPT may be ossigned the some cord reading device. In that case, the cords read on SYSIPT must be placed
in the deck read an SYSRDR os indicated by the broken lines .
• Figure 16. Arrangement of Input for the Execution of the LDSYS Program
70 system/360 Model 20 'IPS Operating Procedures

IBM System/360 20 Specifications

General

Brand	IBM
Model	System/360 20
Category	Storage
Language	English