IBM System/360 20 User Manual

II ASSGN
II VOL
II TPLAB
II UPS I xxxxxxxx
II EXEC
lxxxxxxx
xxxxlxx,x
1xxxlxxx
Reguired for any sym-
bolic address whose
device assign~ent in
main storage is to be
changed.
Required for any sym-
bolic device on which
standard label checking
is to be performed.
Required for standard
label checking. Must
follow the associated
VOL statement.
Required if user rou-
tines are present andl
or no tape mark option
is used.
Possible operands:
For user routines only.
For no tape mark option
only.
For both user routines
and no tape mark
option.
Required.
Any other job control statements
6
such
as DATE, OPTN, LOG, NOLOG, or FILES state-
ments, need be issued only if the corres-
ponding functions are to be requested.
The following program control statements
are used with the file-to-file Utility
programs:
II U (Utility
Modifier)
Optional.
II FS (Field-Select) Optional.
II H (Print-Header)Optional (for Tape-to-
Printer Utility program
only) •
II END Required.
The following program control statements
are used with the Initialize-Tape Utility
program:
II INITTP
VOLl - VOL8
Required.
Required if the operand
CARD is specified in
the INITTP statement.
One to eight statements
(called volume-label
image statements) may
be present for each
output tape specified.
II END
USER ROUTINES
Required after each set
of volume-label image
statements.
If the user wishes to include his own rou-
tines, the assembled routines (one integral
program) must be:
a) inserted in the Utility program deck
(see Figure 11) if the card-resident
system is to be used; or
b) placed behind the program control cards
in the hopper of SYSBDB if the tape-
resident system is to be used.
The first two cards (Loader and Clear
Storage card~) of the user's object deck
must be removed. The last card (END card)
remains in the deck.
!he user must supply an UFSI control
statement with the operand 1 (in the set of
jcb control statements) if he includes his
own routines.
The tape error statistics option can be
requested by including a II CFTN control
statement during the preceding Job Control
run. (280 bytes of main storage will be
used) .
PREPARATION OF THE SYSTEM
The following steps must be taken to pre-
pare the system for the execution of a uti-
lity program.
1. If the system run has not yet been
initiated, follow the procedure
described in the section l~g_~~rd=
]~sidell.L~'y.§.!g.!!!.
2. Place into the hopper of SYSRDR:
a) the card Job Control program deck
(if required);
b) the cards containing the job con trol
statements, if any, between phase 02
and phase 03 of the Job Control
program;
c) the deck containing phase 0 of the
Utility program;
d) the cards containing the program
control statements for the Utility
program;
e) the deck containing phases 1-4 of
the Utility program;
f) user routines, if present;
g} the remainder of the Utility-program
deck.
Use of Language Translators and other IBM-Supplied Processing Programs 39

IBM System/360 20 Specifications

General

Brand	IBM
Model	System/360 20
Category	Storage
Language	English