IBM System/360 20 User Manual

Note: If SYSRDR and SYSIPT refer to the
same card reClding device, the cards
read
on SYSIPT follow those read on
SYSRDR in the hopper.
1*------ -,
;- -- --= = =- -::{'J 1
( Translation Table --r 1 I
~----- --, I
~-----71 I !~~
~r""i;ut;.;s- - - ilL ~
/* If{I-J
Output-Format Specs. L ~
/ - - - - - "71 -~
~------(I
Calculation Specs.
I'//EXEC
I
-----71 I
(1ii;-=Exte=n 5;;;:- - -r 1 ..v~
L I-J
11
JI~ Optional
//j JOB RPG
('File-Description Specs.
/ RPG Control Card
-
-,
SYSRDR SYSI PT
Figure 7. Arrangement of Input for an ~PG Compilation
3. Place into the hopper of SYSIPT:
a) the RPG control card;
b) the source deck (RPG specifications
cards) , consisting of:
• the file-description specifica-
tions cards, identified by an F
in column 6 (one card for each
file; at least one card is
reguired) ;
• the file-extension specifications
cards, identified by an E in
column 6 (optional; required if
table files specified) ;
• the input specifications cards,
identified by an I in column 6
(specifications cards for
alphabetic-sequence records must
precede those for numeric-
sequence records within each
file) ;
• the calculation specifications
cards, identified by a C in
column 6 (optional; if used,
cards specifying detail calcula-
tions must precede those specify-
ing total calculations) ;
• the output-format specifications
cards, identified by an 0 in
column 6 (required; all heading
specifications cards, followed by
all detail specifications cards,
followed by all total specifica-
tions cards for all files);
c) an end-oi-file card (/* in cols.
1-2, remaining cols. blank);
~ the userts assembled subroutines (if
any) ;
e) an end-of-file card (if user subrou-
tines are present) ;
f) the translation table (if required)
consisting of four cards identified
by an S in column 6;
g) an end-of-file card (if a transla-
tion table is present).
Note: If SYSRDR and SYSIPT refer to
the-same card-reading device, the deck
that is to be read from SYSIPT must
immediately follow the EXEC card.
4. If the prin~er is assigned to SYSLST
and/or SYSLCG, press the Reset key and
the start key of the printer.
5. Mount a work tape on the tape drive
assigned to SYSOOO and press the Load-
Rewind key and the Start key of the
d ri ve.
6. If the use of a second work tape has
been specified, mount a second work
tape on the tape drive assigned to SYS-
001 and press the Load-Rewind key and
the start key of the drive.
7. If the REG object program is to te
punched into cards, place blank cards
into the hopper of the punching device
assigned to SYSOPT.
8. If the RPG object program is to be
written onto a tape, mount an appropri-
24 System/360 ~odel 20 TPS Operating Procedures

IBM System/360 20 Specifications

General

Brand	IBM
Model	System/360 20
Category	Storage
Language	English