IBM System/360 20 - 158

,-- i -,-- I ,
I Code I Cause I Restart I Ref. No. I
) :r::STR ) I I I
l- I -+ I I
I 1C53 IFirst record of output tape is not a IOperator choice: I 58 I
) Istandard volume label when standard la} Mount correct reel and pressl I
I
Ilabels are specified. I START on CPU to continue I I
) I I processing. I I
I I I
b} Enter OF into location CE I I
) ) I and press START on CPU to I )
I I I continue processing. (The I I
I
) I tape is accepted.) I I
I I Ic}
Enter FF into location CE I 53 I
) I I and press START on CPU to I I
I I I
discontinue the job. I I
,..----+------. --t- +-----i
I 1C54 Volume serial number in standard ICperator choice: I 58 I
I volume label on output tape does not la) Press START on CPU to I I
) correspond to file seri al num ber in ) cantin ue processing. (The I I
I TPLAB con trol statement. I tape is accepted.) I I
) ) b) Mount correct reel, enter) I
I
) OF into location CE, and I I
I I press STABT on CPU to I I
I
I continue processing. I I
I Ic) Enter FF into location CE I 53 I
I
I and press START on CPU to I I
I I discontinue the job. I I
1-- I + I --I
I 1C56 IOutput tape is not at lead point when IOperator choice: I 58 I
1 Istandard labels are specified, and no la} Mount correct reel and I I
I I precedin9 trailer label has been I press START on CPU to I I
I I found. I can tin ue processing. I I
I I Ib) Enter FF into location CE I 53 I
I
I I and press START on CPU to) I
) I I discontinue the job. I I
J----+----- I +----f
) 1C57 IOutput tape is not at load point, and I Operator choice: 58 I
I
Ifile serial number of preceding trailer la} Press START on CPU to )
I Ilabel dOE~s not correspond to information) continue processing. (The I
) lin TPLAB control statement. I tape is accepted.) I
J-------+ 1b) Mount correct reel, enter I
] 1C5B IOutput tape has not expired. I OF into location eE, and I
I I I
press START on CPU to I
1 I I continue processing. I
I
) Ie) Enter IF into location CE 53 I
I I
) and press START on CPU to I
I I I discontinue the job. I
J- I I ~
I 1C5C IMODS statement specified, but no user I 60 I
I
Iroutine present. I I I
J- I I t-----t
I 1D01 lEnd of RPG compilation. ) Prepare the I/C devices I I
I I
Irequired by the object program I I
) I I and press STABT on CPU to I I
I I
linitiate execution. I I
L I I -'--- ___ --I
158 system/360 Model 20 TPS Operating Procedures