IBM System/360 20 User Manual

blank
18
2
blank
19
o
2
blank
20
o
2
blank
21
I
blank
22 B
blank
BS I format.
The input does not con-
tain sterling-currency
fields.
The pence portion of a
sterling-currency input
field is in the IBM
format.
The pence portion of a
sterling-currency input
field is in the BSI
format.
The input does not con-
tain sterling-currency
fields.
The shillings portion of
a sterling-currency out-
put field is in the
prin ter format.
The shillings portion of
a sterling-currency out-
put field is in the IBM
form at.
The shillings portion of
a sterling-currency out-
put field is in the BSI
form at.
The output does not con-
tain sterling-currency
fields.
The pence portion of a
sterling-currency output
field is in the printer
format.
The pence portion of a
sterling-currency output
field is in the IBM
fo rm at.
The pence portion of a
sterling-currency output
field is in the BSI
format.
The output does not con-
tain sterling-currency
fields.
The Inverted-Print
option is chosen (i. e.,
commas are used instead
of decimal points).
The Inverted-Print fea-
ture is not to be used.
An additional input area
for the 2501 is to be
reserved in main
storage. This may
alternatively or addi-
tionally be specified in
column 32 of the File
Description
specificat ion.
An additional input area
is not required.
23-25 100
or blanks
120
132
144
26 T
blank
27-30 xxxx
blank
31 1 or
blank
2
32
blank
22 System/360 Model 20 TPS Operating Procedures
100 print positions are
required during object
program execution.
120 print positions are
required during object
program execution.
132 print positions are
required during object
program execution.
144 print positions are
required during object
program execution.
!Q!~~ The entries in
these columns are used
only if the file-
description cards for
the printer file do not
contain block-length and
record-length
specifications.
User's translation table
is to be read during
compilation to transl-
ate, during the object
run, alphameric fields
for the purpose of alt-
ering the collating
sequence.
Translation table is not
to be read.
Begin address of object
program, in decimal
notation (must be higher
than 1653). If the
read/compute, write/
compute overlap feature
is used (execution on a
Submodel 5; W in col.
38 of the TPS RPG con-
trol card), the address
must be 2100 or higher.
RPG assumes object pro-
gram to begin at (decim-
al) address 1664 if the
read/compute, write/
compute overlap feature
is not used, or at 2100
if the feature is used
(execution on a Submodel
5 only; W in col. 38 of
the TPS RPG control
card) •
RPG is to use one work
tape (SYSOOO) for
compilation.
RPG is to use two work
tapes (SY5000 and 5YS-
001) for compilation.
The OPEN routine of the
object program may be
overlaid with I/O areas.
The OPEN routine must

IBM System/360 20 Specifications

General

Brand	IBM
Model	System/360 20
Category	Storage
Language	English