IBM System/360 20 - 159

r----~ --~i-------
I Code ICause I Restart
I ESTR I I
l- I I
I 1D02 IIrrecoverable error. Caused by main- I Press START on CPU to
I Istorage overflow during generation, or Idiscontinue the job.
I lobject program too large for available I
I I
main-storage capacity as specified I
I
lin cols. 12 - 14 of RPG control card, I
I I or RPG control card missing or in- I
I I
correct, or errors in source deck. I
I I
-t
I 1D03 Conflicting tape-drive assignments. I
) (SYSRES, SYSOOO, and SYS001 must be I
I
different ta~e drives; SYSOPT, if I
I
tape drive, must not be the same drive I
I
as SYSRES or SYS001), or required I
I
tape drive not assigned, or SYSIPT I
I
is not a card reading device, or a I
I 7-track tape drive is assigned to I
I SYSOOO or SYS001 and the conversion I
I feature is not on. I
I -t
I 1D11 Permanent read error on SYSOOO. I
~---+- -----------1
I 1D12 IPermanent read error on SYS001. I
I I -t
I 1 D21 I Unit ex ception on S YS 000. (During read I
I loperation, tape mark encountered where I
I
Inot expected. During write operation, I
-,------,
IRef.No. I
I I
-+-------1
53
I lend of reel sensed • .) I I
I I -+------------------------+-----1
I 1D22 IUnit exception on SYS001. (During read IPress START on CPU to I 53 I
I
loperation, tape .ark encountered where I discontinue the job. I I
I Inot expected. During write operation, I I I
I lend of reel sensed.) I I I
I , --1.. I I
Programmed-Halt Displays and Restart Procedures 159