IBM System/360 20 - 143

I I -.----------
I Code ICause IRestart
I ESTR I I
I I t
I OEOF INo TPLAE information has been found for IPress START on CPU to
I la file in the label-information area. I discontinue the job.
I I -1
I OE10 IToo many TPLAB statements have been I
I
Iread for the current program; or CONFG I
I Istatement is incorrect for the I
I Icurrent program. I
I I -+
I OE11 IOutput tape is not at load point, and IOperator choice:
I Ifile serial number of preceding trailer la) Press START on CPU to
I Ilabel does not correspond to information I discontinue the job.
I lin TPLAE statement. Ib) Enter FF into location CE
I I I and press START on CPU to
I I I continue processing.
I ,
I Ref. No. I
I
+----~
57
53
57
53
I I +
------+-----1
I OE12 Output tape has not expired. IOperator choice:
r----+----- ~a} Press START on CPU to
I OE13. Volume serial number in standard volume I discontinue the job.
I label/does not correspond to file Ib) Enter OF into location CE
I serial number in TPLAB statement. I and press START on CPU to
I I continue processing with
I I mounted reel.
I Ic) Mount correct reel, enter FF
I I into location CE, and press
I I START on CPU to continue
I I processing.
57 I
53 I
I
I
I
I
I
I
I
I
I
I I
~
--+----1
I OE14 IFor an input file, no trailer label has IOperator choice:
I Ibeen read after the tape mark although la) Press START on CPU to
I Istandard labels have been specified. I discontinue the job.
I I Ib) Enter OF into location CE
I I I and press START on CPU to
I I I continue processing with
I I I end-of-file condition.
I I Ic) Enter FF into location CE
I I I and press START on CPU to
I I I continue processing with
I I I end-of-volume condition.
r---t I
I
OE15 IRequired tape drive has not been I Press START on CPU to
I I assigned. Idiscontinue the job.
j-----~ I
I OE1A IRead/compute write/compute overlap I Press START on CPU to
I Ifeature has been specified with the Idiscontinue the job.
I IEXEC RWC statement, but no DTFBG I
I
IRWC=YES was issued during generation. I
I----t_ -f
I OE1D IDTFBG=YES has been specified I
I
Iduring generation but no EXEC RWC I
I
Istatement was issued. I
I I -1
I OE9A I Read/compute write/compute overlap I
I
Ifeature was specified by Rwe in EXEC I
I
Istatement, but RPG control card has a I
I
Iblank in col. 38. I
I I -1
I OE9B I Read/compute write/compute overlap I
I
Ifeature was not specified in the EXEC I
I
Istatement, but RPG control card has a I
I I Win col. 38. I
~ ____ ~!_____ i
57 I
53 I
I
I
I
I
I
I
I
I
I I
t_-----t
I 53 I
I I
t------t
53 I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
.J
Programmed-Halt DisFlays and Restart Procedures 143