IBM System/360 20 User Manual

II PUNCH ALL
II PUNCH nnnnnn.ALL
1/ PUNCH
and
II MONTR
II END
Required if all pro-
gram phases con-
tained in the core-
image library are to
te punched.
Requir ed if all pro-
gram phases whose
names tegin with a
character combina-
tion identical to
that preceding the
period in the
operand field are to
be printed.
Required if the tape
Basic Monitor pro-
gram is to be
punched.
Required. Must be
the last program
control statement.
As many DSPLY and PUNCH statements as
desired may be submitted to the CSERV pro-
gram in any order.
The program con trol statements for the
CSERV program are read on the device
assigned to SYSRrR.
PREPARATION OF THE SYSTEM
The operator must take the following steps
to prepare the system for the execution of
the CSERV program.
1. If the system run has not yet been
initiated, follow the procedure
described in the section lB§_l~~~=
.!!g§i~gn1_~Y.§ig!!!.·
2. Place into the hopper of SYSRDR:
•
the cards containing the job control
statements
• the cards containing the program
control statements.
3. Press the Start key of the device
assigned to SYSRDR.
4. If the printer is to te used as SYSLST
andlor SYSLOG, prepare and start this
device.
5. If a card punching device has been
assigned to SYSOPT, place blank cards
in the hopper of the device and press
the Start key.
6. Mount a work tape on the drive assigned
to SYSOOO. Press the Load-Rewind key
and the Start key of this drive.
7. Press the Start key on the CPU console
(or the Load key if the execution of
the CSERV program is the first jot in
the system run) •
PROGRAMMED HALTS
A number of programmed halts may occur dur-
ing the loading and execution of the TPS
Core Image Service program. The halt-code
dis}lays and the associated restart proce-
dures are described in the section E~Q=
g~~mm~g_li~1!~i§Elg1§_§nd Besta~!
!:£Q.f~gg£~§.
MESSAGES
A number of messages mal te printed during
execution of the CSERV program. They are
printed on either SYS[CG or SYSLST (depend-
ing on the kind of message).
DESCRIPTION OF OUTPUT
The output from the CSERV program consists
of:
• printed output, andlor
• output in cards.
Each phase for which printing has teen
requested by a DSPLY card is listed on the
printer. The listing includes:
• information from the header record
for the phase (and any subphases),
and
• a hexadecimal print-out of the phase
(and any sub~hases).
If a card-punching device has been assigned
to SYSOPT, the output requested by means of
PUNCH statements comprises the fcllowing
cards.
a) For the Basic Monitor program:
II MONTR
ESe card
TXT cards
END card
II ENL
II [CArC
64 system/360 Model 20 TPS Operating Procedures

IBM System/360 20 Specifications

General

Brand	IBM
Model	System/360 20
Category	Storage
Language	English