IBM System/360 20 - 147

i --r- i "1
Code ICause IRestart IRef.No.1
ESTR I I I I
I +-----------------------+-----1
1B24 IThe name of a control section is the IPress START on CPU to 53
Isame as that of a preceding control Idiscontinue the job.
I Isection. I
.---+- -f
I 1B25 IAn ESID number is multiply defined I
I
Iwithin one control section. I
.-----~ -f
I 1B26 IToo many pha~e, control section, ENTRY, I
I
land/or EXTRN names have been used for I
I I
the specified stor age cap acity • I
I I -1
I 1B27 IAn ESID number that is not defined in I
lithe control section has been referenced I
I
lin an RLD, TXT, REP, END, or XFR record. I
.. I -f
I 1B28 IAn ESID number in an RLD, TXT, REP, END,I
I
lor XFR record has been defined in the I I
I ,control section, but do es not refer to I I
lithe section Definition entry for this I I
I
Isection. I I
I I -1 I
I 1B29 IA TXT record pertaining to a previously I I
I
Iprocessed phase has been encountered. I I
I I
-t I
I 1B2A IThe name used in a section Definition I I
I
lentry is the same as the name used in ani I
I
IAssembler ENTRY statement in a precedingl I
I
Icontrol section. I I
I I +-- -t
J 1B2B I ACTION control statement cont.ains IPress START on CPU to continue I
I
linvalid operand. Iprocessing (Statement is I
I I
lignored.) I
• I I -f
I 1B2C IThe (optional) name in an ENTRY control I Press STABT on CPU to 53
I Istatement has not been defined as the Idiscontinue the job.
I Iname of a phase or control section or I
I
las the name used in an Assembler ENTRY I
I
Istatement. I
I-- I -t
I 1B2D 11st operand of PHASE statement is I
I I
incorrect. I
I I -t
J 1B2E 12nd operand of PHASE statement is I
I I
incorrect. I
I I -1
I 1B2F 13rd operand of PHASE statement is I
I
lincorrect. I
I I -+- -I
I 1B30 14th operand of PHASE statement is IPress START on CPU to 53
I lincorrect or not previously defined. Idiscontinue the job.
1 I -t
I 1B31 No device assigned to required symbolic I
I addressees), or the same tape drive I
I
assigned to more than one symbolic I
I
address used, or incorrect device I
I
type(s) assigned. I
• -f
I 1B32 Symbolic transfer address in an END or I
I
XFR record has not been defined I
I
previously. I
..L-
Programmed-Halt Displays and Restart Procedures 147