9
D-ST
AR OPERA
TION <AD
V
ANCED>
9-28
Repeater list programming (Continued) ■
Access repeater setting7.
The programmed repeaters can be used as an ac-
cess repeaters in the DR mode.
For simplex operation, or when the programmed
repeater is not used as an access repeater, select
“NO.” In this case, the programmed repeater does
not appear in the “FROM” selection.
@9 Push D-pad() to select “USE(FROM),” and then
push D-pad(Ent).
#0 Push D-pad() to select “YES,” and then push D-
pad(Ent).
• You can select the programmed repeater as an access
repeater (FROM).
Access repeater frequency programming8.
This item appears only when “YES” is selected in
[7. Access repeater setting].
#1 Push D-pad() to select “FREQUENCY,” and then
push D-pad(Ent) to enter the frequency edit mode.
• A cursor appears and blinks.
#2 Rotate [DIAL] to input the 100 MHz digit of the fre-
quency.
#3 Push to move the cursor backward, or push to
move the cursor forward.
#4 Repeat steps #2 and #3 to enter the frequency.
#5 After entering, push D-pad(Ent).
Example:
“439.340.00” is
entered.
☞ Continued on the next page.
To Next Page
Loading...
Need help?
General
