Programming IDEC SmartRelay
80 IDEC SmartRelay Manual
Changing the password from the IDEC SmartRelay Base module
You must know the current password in order to change it.
In the programming menu:
1. Move the ’>’ cursor to ’Password’: Press or
2. Confirm the ’Password’: Press OK
Select “Old” and enter your old password (in our case: ’AA’) by repeating
steps 3 through 6 as described earlier.
The display now shows:
Now you can select “New” to enter the new password, e.g.
“ZZ”:
3. Select “Z”: Press
4. Move to the next letter: Press
5. Select “Z”: Press
The display now shows:
6. Confirm your new password: Press OK
Your new password “ZZ” is now se
t, and you are returned to
the programming menu.
Deactivating the password from the IDEC SmartRelay Base module
To deactivate the password to allow, for example, another
user
to edit your circuit program, you must know your current
password (in our example “ZZ”), the same as if you were
changing it.
To deactivate the password, following these steps in the
pr
ogram
ming menu:
1. Move the ’>’ cursor to ’Password’:
Press or
2. Confirm the ’Password’: Press OK
Select “Old” and enter your current password as described
in
steps 3 to 5. Co
nfirm your entries with OK.
To Next Page
Loading...
