Programming IDEC SmartRelay
IDEC SmartRelay Manual 65
Note
You can cancel the input of a new password with ESC. In this case,
IDEC SmartRelay returns to the programming menu without saving
the password.
You can also set your password using WindLGC. You can not edit
a password-protected circuit program at the IDEC SmartRelay or
upload it to WindLGC unless you enter the correct password.
To allow you to create and edit a circuit program for a protected
memory cartridge (card), you first need to assign a password to this
new program (see Chapter 6.1).
Changing the Password
You need to know the current password in order to change it.
In the programming menu:
1. Move the '>' cursor to 'Password': Press ▼ or ▲
2. To confirm the 'Password': Press OK
Select “Old” and enter your old password (in our case: 'AA')
by repeating steps 3 through 6 as described earlier.
The display now shows:
Now you can select “New” to enter the new password, e.g.
“ZZ”:
3. Select “Z”: Press ▲
4. To move to the next letter: Press
5. Select “Z”: Press ▲
▲
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...
Need help?
General
