Inficon Micro GC Fusion 2-Module

6 | Installation INFICON
98 / 319 074-594-P1H Micro GC Fusion Operating Man-
ual
6.13.1 Installing the Valco Stream Selector Accessories
6.13.1.1 Equipment Required
The following tools are required to install and connect sample lines to the Valco
stream selector accessories:
• two 1/4 in. wrench
• one 5/16 in. wrench
• one 7/16 in. wrench
• 1/16 in. OD stainless steel sample line(s)
6.13.1.2 Valco Stream Selector Accessories
INFICON offers a 10-port SD and a 10-port SF Valco stream selector as an
accessory.
When sample or calibration gas is in short supply and sample composition does not
change drastically over time, the dead-ended (SD) Valco stream selector is the
desired choice.