Inovance MD500-PLUS Series - Page 182

Parameter Groups
‑181‑
F4-32
Pulse filter time
Address:
0xF420
Min.:
0
Unit:
s
Max.: 10 Data type: UInt16
Default:
0.1
Change: In real time
Value Range:
0.00s to 10.00s
Description
Indicates the filter time of the frequency reference.
F4-33
AI curve selection
Address:
0xF421
Min.:
0x111
Unit:
‑
Max.: 0x555 Data type: UInt16
Default:
0x321
Change: In real time
Value Range:
Ones: AI1
1: Curve 1 (2 points, see F4‑13 to F4‑16)
2: Curve 2 (2 points, see F4‑18 to F4‑21)
3: Curve 3 (2 points, see F4‑23 to F4‑26)
4: Curve 4 (4 points, see A6‑00 to A6‑07)
5: Curve 5 (4 points, see A6‑08 to A6‑15)
Tens: AI2
1: Curve 1 (2 points, see F4‑13 to F4‑16)
2: Curve 2 (2 points, see F4‑18 to F4‑21)
3: Curve 3 (2 points, see F4‑23 to F4‑26)
4: Curve 4 (4 points, see A6‑00 to A6‑07)
5: Curve 5 (4 points, see A6‑08 to A6‑15)
Hundreds: AI3
1: Curve 1 (2 points, see F4‑13 to F4‑16)
2: Curve 2 (2 points, see F4‑18 to F4‑21)
3: Curve 3 (2 points, see F4‑23 to F4‑26)
4: Curve 4 (4 points, see A6‑00 to A6‑07)
5: Curve 5 (4 points, see A6‑08 to A6‑15)
Description
The curves for AI1 to AI3 are set through the ones, tens, and hundreds positions of
this parameter. The three AI terminals can be allocated with any of the five curves.
When the main frequency is set by analog input, the AI terminals are used as
frequency sources. Five types of different AI curves can be set for each AI terminal.
F4-34
Selection of AI smaller than the minimum input setting
Address:
0xF422