Parameter List
‑26‑
Parame
ter
Address Name Value Range Default Unit Change
Method
Page
F4‑39 0xF427 DI valid mode
selection 2
Ones: DI6 valid mode
selection
0: Active high
1: Active low
Tens: DI7 valid mode selection
0: Active high
1: Active low
Hundreds: DI8 valid mode
selection
0: Active high
1: Active low
Thousands: DI9 valid mode
selection
0: Active high
1: Active low
Ten thousands: DI10 valid
mode selection
0: Active high
1: Active low
0 ‑ At stop "
F4‑39
"
on
page 184
F4‑42 0xF42A AI input range
selection
0: ‑10 V to +10 V
1: 0 V to 10 V
0 ‑ In real time "
F4‑42
"
on
page 184
F5‑01 0xF501 Expansion card
relay output
function selection
0: no output
1: Running
2: Fault output (stop upon
fault)
3: Frequency‑level detection
FDT1 output
4: Frequency reached
5: Zero speed running (no
output at stop)
6: Motor overload pre‑warning
7: AC drive overload pre‑
warning
8: Set count value reached
9: Designated count value
reached
10: Length reached
11: PLC cycle completed
12: Accumulative running time
reached
13: Frequency limited
14: Torque limited
0 ‑ In real time "
F5‑01
"
on
page 185
To Next Page
Loading...
