Inovance MD500-PLUS Series - Page 389

Parameter Groups
‑388‑
When analog voltage correction is carried out on the AO2 terminal, a correction
curve is formed through two points, and each point corresponds
to a target voltage and a measured voltage. The target voltage is the expected
output voltage, and the measured voltage is the output voltage actually
measured.
AC-18
AO2 measured voltage 2
Address:
0xAC12
Min.:
‑10
Unit:
V
Max.: 10 Data type: Int16
Default:
8
Change: In real time
Value Range:
‑10.000 V to +10.000 V
Description
When analog voltage correction is carried out on the AO2 terminal, a correction
curve is formed through two points, and each point corresponds
to a target voltage and a measured voltage. The target voltage is the expected
output voltage, and the measured voltage is the output voltage actually
measured.
AC-19
AO2 target voltage 2
Address:
0xAC13
Min.:
‑10
Unit:
V
Max.: 10 Data type: Int16
Default:
8
Change: In real time
Value Range:
‑10.000 V to +10.000 V
Description
When analog voltage correction is carried out on the AO2 terminal, a correction
curve is formed through two points, and each point corresponds
to a target voltage and a measured voltage. The target voltage is the expected
output voltage, and the measured voltage is the output voltage actually
measured.
AC-20
PT100 measured voltage 1
Address:
0xAC14
Min.:
0
Unit:
V
Max.: 3.3 Data type: Int16
Default:
0.44
Change: In real time
Value Range:
0.000 V to 3.3 V