Intel Stratix 10 Configuration User Guide

9.
On the Edit Partition dialog box, select Bitstream_1 as the factory image .sof
in the Input file drop-down list. Keep the default settings for Page 0 and
Address Mode. Click OK.
10. Select the MT25QU02G flash memory and click Add Partition.
11. In the Add Partition dialog box, select Bitstream_2 for the application
image .sof in the Input file drop-down list. Assign Page: 1.Keep the default
settings for Address Mode. Click OK.
12. For Flash loader click Select. Select Stratix 10 from Device family list. Select
1SX280LU3S2 for the Device name. Click OK.
13. Click Generate to generate the remote system upgrade programming files. The
two following files are generated:
a.
Initial_RSU_Image.jic
b.
Initial_RSU_Image_jic.map
The following example output shows the generated .map file. The .map lists the start
addresses of the factory image, CPB0, CPB1, and application image. The remote
system update requires these addresses.
BLOCK START ADDRESS END ADDRESS
BOOT_INFO 0x00000000 0x0010FFFF
FACTORY_IMAGE 0x00110000 0x002D3FFF
SPT0 0x002D4000 0x002DBFFF
SPT1 0x002DC000 0x002E3FFF
CPB0 0x002E4000 0x002EBFFF
CPB1 0x002EC000 0x002F3FFF
Application Image 0x002F4000 0x004B7FFF
Configuration device: 1SX280LU3S2
Configuration mode: Active Serial x4
Quad-Serial configuration device dummy clock cycle: 15
5. Remote System Upgrade
UG-S10CONFIG | 2018.11.02
Send Feedback
Intel Stratix 10 Configuration User Guide
89

Intel Stratix 10 Specifications

General

Brand	Intel
Model	Stratix 10
Category	Control Unit
Language	English