Installing BDU
41
Red (positive)
Black (negative)
For the DC power wires, Red (positive) and Black (negative), you can
connect each wire with other wires using the terminal block.
1. Open the top cover of the terminal block.
2. Unscrew the 1st position terminal using a Phillips screwdriver. Insert
the ring connector of the Red (positive) wire to the terminal and
tighten the screw back into the terminal.
3. Unscrew the 3rd position terminal using a Phillips screwdriver. Insert
the ring connector of the Black (negative) wire to the terminal and
tighten the screw back into the terminal.
Red
(positive)
Black
(negative)
4. Connect wires for distribution to the terminals on the opposite side
of each connected wires.
CAUTION: DO NOT switch positions of the Red (positive) and Black
(negative) wires. Switching the polarity of power may damage the
product.
5. Close the top cover of the terminal block.
To Next Page
Loading...
Need help?
General
