Invacare Storm 4 - Backrest Unit with Ergonomic Length Compensation (Easy-Adapt); Adjusting the Width

Invacare®Storm®⁴
6.Placetheheadlightsincludingtheirholderssafelyontherear
sectionofthebatteryboxcover.
7.Removethecoverplates(1).
8.UndothetwoAllenscrews(9)atthefrontontheseatsupport
plateandremovethem.
9.UndothetwoAllenscrews(7)whicharelocatedonthesideat
thefrontoftheseatsupportplate,andconnectthesetothe
crossmembers(4).
10.UndothetwoAllenscrews(8)whicharelocatedontheside
attherearoftheseatsupportplate,andconnectthesetothe
crossmembers(4).
11.Removetheseatsupportplate(2).
12.Repeattheseoperationsontheothersideoftheseat.
13.UndoandremovethetwoAllenscrews(5)includingwashers.
Assembly:
1.PulltheseatsupporttotherequiredlengthsothattheAllen
screws(5)canbeinsertedintheholesinaccordancewiththe
table(seeabove).
2.InserttheAllenscrews(5)includingwashersagainandtighten
them.
3.Ifnecessary,replacetheseatsupportplate(2)inaccordance
withthetable(seeabove).
4.Puttheseatsupportplate(2)backinposition.
5.FitthetwoAllenscrews(7)whicharelocatedatthefrontofthe
seatsupport,andconnectthemwiththecrossmembers(4).
6.FitthetwoAllenscrews(8)whicharelocatedattherearofthe
seatsupport,andconnectthemwiththecrossmembers(4).It
maybenecessarytouseotherholesinthe3holepairsforthe
screwsthanyoudidwhiledismantlingtheoldplate.
7.FitthetwoAllenscrews(9)atthefrontoftheseatsupportplate.
8.Refitallthepartsyouhaveremoved.
6.14Backrestunitwithergonomiclength
compensation(Easy-Adapt)
6.14.1Adjustingthewidth
NOTE
–Alsorefertothepreviouschapterentitled6.13.1
Adjustingseatwidth,page48
.
–Theseatcanbeadjustedinstagesbetween380and
530mm.
Requirements:
•4mmAllenkey
1.Removethebackrestcushion.
2.LoosenthethreeAllenscrews(1).Donot,however,remove
thesescrewscompletely.
3.Pushtheplate(2)asfarasrequireduntiltherequiredwidthin
cmcanbereadoffthescale(3).
4.TightenthethreeAllenscrewsagain.
521529686-P