iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
120
4.4.4.7 DISA Service Attributes - PGM 146
Selecting DISA Service Attributes will display the DISA Service Attributes data input page.
Enter a valid CO range and click [Load] to enter the DISA Service Attributes data.
Use the checkmark to indicate which attributes to modify; checked attributes are stored by clicking the [Save]
button.
Enter CO Range: eMG80/100: 1-74 / eMG800: 1-600 / UCP: 1-998
Figure 4.4.4.7-1 DISA Service Attributes
DISA Service can be enabled on CO lines based on the system operation mode (Day, Night, and Timed).
DISA call may be routed to dial tone and await user dialing (simple routing) or through a multi-layered Audio
Text menu assigning a VSF Announcement and a Customer Call Route (CCR) Table Index.
The system can be programmed to disconnect after the announcement, ‘Auto Drop,’ or follow the CCR Table
routing with a user-recorded announcement requesting specific inputs from the user.
To Next Page
Loading...
