iPECS UCP100 - Station Timers - PGM 123

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
85
4.4.2.14 Station Timers - PGM 123
Selecting Station Timers will display the Station Timers input page.
Enter a valid Station range and click [Load] to enter the Station Timers data. Use the checkmark to indicate
which attributes to modify; checked attributes are stored by clicking the [Save] button.
Figure 4.4.2.14-1 Station Timers
Certain timers can be assigned on a station basis. Available timers, descriptions, and valid inputs are given in
the below table.
Table 4.4.2.14-1 STATION TIMERS (PGM 123)
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Station Forward No
Answer Timer
This timer sets the duration that the station
will ring before Ring-No-Answer Forward.
This setting affects manual and ‘Preset Call
Forward’ and overrides ‘Call forward No
Answer timer in System timer of System
data.’
000-600
(seconds)
000
Cut Off Timer
Allowed length of CO/IP calls when a station
is assigned ‘Call Time restriction in Common
Attributes of Station data.’
00-99
(minutes)
00