iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
270
4.4.8.6 SIP User ID Attributes – PGM 126
Selecting SIP User ID Attributes will display the SIP User ID input page.
Enter a valid SIP User ID Index Number range, see Station Data, and click [Load] to view the SIP User ID
Attributes for the first index in the range.
Enter new data and click [Save] to modify the attributes for the index range.
Enter SIP User IDIndex number: eMG80/100: 1-140 / eMG800: 1-1200 / UCP: 1-2400
Figure 4.4.8.6-1 SIP User ID Attributes
An index to the SIP User Id Attributes Table is defined in PGM 111 Station Attributes for each station.
The SIP User Id Attributes Table defines SIP characteristics associated with the index, including User ID,
Authentication name, etc.
These characteristics are required for proper operation of the system and registration of the iPECS IP and
LDP phones when employed with the SIP trunk. See also, PGM 133.
Note PGM 126 and PGM 133 are accessible only via Web Admin.
Setting CID Password directly
You can set the CID password by clicking the “Go to Setting” button. After clicking it, you will move to the
following PGM 162, set the CID password, save the CID password from the marking tick on the save box, and
click the Save button.
To Next Page
Loading...
