iPECS UCP100 - Prefix Dialing Table - PGM 206

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
244
4.4.7.7 Prefix Dialing Table - PGM 206
Selecting ISDN Prefix Dialing Attributes will display the Prefix Dialing Table Attributes data entry page. For
convenience, the copy, paste, and drag are available to enter or modify data. Click the [Save] button after
changing Value.
Figure 4.4.7.7-1 Prefix Dialing Table Attributes
Prefix Dialing Table. With this table, three features can be supported.
 CO Call Charge with NPR metering.
 SIP direct dialing with no wait inter-digit timer.
 ISDN Prefix Call – ISDN en-block Dialing with Prefix Call Setup.
If first some digits (up to 8 digits) of outgoing dial number are matched with Prefix Code of each table, this
table can start work. By each Co-line (PGM 142 – F20), Table ID (0-6) can be set. This table ID (PGM 142 –
F20) is associated with PGM 206 – each table ID.
Table 4.4.7.7-1 Prefix dialing Table Attributes
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Prefix Code
Enter the Prefix code. (Max 8 digits)
Max. 8 Digits(Include * and #)
Refer to
description
Table ID
Enter Table ID (0-6). 0 means NOT used.
0-6
0
Min Digit
Select the minimum dial digits (00-30).
00-30
0
Max Digit
Select the maximum dial digits (00-30).
00-30
0
Number Of
Type
Select Number of Type (0~6).
 Unknown
 International
 National
 Network Spec
 Subscriber
 Abbreviated
 Reserved.
Refer to
description
Unknown