iPECS UCP100 - Flexible Button Default Table- PGM 239

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
317
4.4.9.20 Flexible Button Default Table– PGM 239
Selecting the Flexible button default table will display the below page. For convenience, the copy, paste, and
drag are available to enter or modify data. Please click the [Save] button to apply after changing Value.
Figure 4.4.9.20-1 Flexible Button Default Table
The system provides 30 default flexible button tables so the administrator can configure each table using
‘Preset Flexible Button Default (240)’. The administrator can assign the type among the below types on the
Flexible button.
Table 4.4.9.20-1 FLEX BUTTON TYPE
TYPE
REMARK
N/A
Empty (unassigned) may be defined by the user.
CO Line
Assigns a button to access a defined CO/IP line.
CO Group
Assigns a button to access a free line in the CO/IP Group.
Loop
Assigns a button to access a loop line.
Station Number
Assign a button as DSS/BLF for the assigned station number.
Programming
(Numbering Plan)
Assigns a button to dial a code from the Flexible Numbering Plan. See Appendix
section.
Programming (PGM)
Assigns a button to perform a User Program function from the Fixed Numbering Plan,
Appendix section.
Station Speed Bin
Station Speed Dial bin.
System Speed Bin
System Speed Dial bin.
Net Station Number
Refer to section Network Numbering Plan Table - PGM 324.
U-Loop
U-Loop button for call wait of internal & external call.
Dial Digit
Assign button for any dial digit.