iPECS UCP100 - Web Admin Programming; System ID & Numbering Plans; System ID - PGM 100

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
32
4.4 Web Admin Programming
4.4.1 System ID & Numbering Plans
Selecting the System ID & Numbering Plans expands the Navigation frame to display the available Program
groups below.
Figure 4.4.1-1 System ID & Numbering Plans sub-menu
4.4.1.1 System ID – PGM 100
Selecting System ID will display the following Input Entry page. Click [Reset System] to restart the system
after changing Nation code, Site name, Site detail, My area code, Multi-area code, Numbering Plan, etc.
Figure 4.4.1.1-1 System ID
Under System ID, the country is identified using the international dial codes (Nation Code). A twenty-four (24)
character Site Name, Site detail, and the local My Area Code may be defined. This information set gain,
frequencies, and other system characteristics specific to the country and regional regulatory requirements.
The Site Name is primarily useful for the installer/programmer as a reference to the customer.
Note)
 In eMG, to change the Nation code, Dip-switch 1 pole # 2 is ON; you cannot change the Nation code
while the switch is OFF.
 In UCP, to change the Nation Code, the UCP Module “Mode” dipswitch pole 4 must be ON; you
cannot change the Nation code while the switch is OFF.
 The rest attributes are additional options for the Customer’s convenience.
 In the case of UCP, the built-in VoIP DSP channels (VOIU) can be disabled, allowing the DSPs for the
Multi-party Conference function.
 In the case of UCP100, SLIU channels cab be disabled or enabled.