iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
70
4.4.2.4 CLI Attributes - PGM 113
Selecting CLI Attributes will display the CLI Attributes data input page. Enter a valid station range and click
[Load] to enter CLI Attributes data.
Use the checkboxes to indicate which attributes to define; data for checked attributes is stored for the entire
range of stations by clicking the [Save] button after changing Value.
Figure 4.4.2.4-1 CLI Attributes (PGM 113)
CLI Attributes define features and functions available to the station. Generally, the entry will turn the feature
ON (enable) or OFF (disable) or enter the text box. Refer to the following table for a description of the features
and the input required.
Setting CID Password directly
You can set the CID password by clicking the [Go to Setting] button. After clicking it, you will move to the
following PGM 162, set the CID password, save the CID password from the marking tick on the save box and
click the [Save] button.
When a busy station receives a call, the call may queue to the
station instead of receiving busy treatment. Call Wait will hear
a Ring-back tone, and the CO/IP Line LED flashes with Call
Wait. Also, the CLI for the new incoming call displays.
OFF, For External/Internal, For External, For Internal
To Next Page
Loading...
