iPECS UCP100 - Network Basic Attributes - PGM 320

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
321
4.4.10.1 Network Basic Attributes - PGM 320
Selecting Network Basic Attributes will display the Network Basic Attributes entry page. Click the [Save] button
after changing Value.
Figure 4.4.10.1-1 Network Basic Attributes
Table 4.4.10.1-1 NETWORK BASIC ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Net Enable
For operation, the Networking function must be enabled here.
Note a license is required.
OFF
ON
OFF
Net Retry Count
Not used.
00-99
0
Net CNIP Enable
The name of the calling station is sent to the called iPECS UCP.
CNIP is shown in the LCD of the called party’s station.
OFF
ON
ON
Net CONP
Enable
The name of the connected station is sent to the calling iPECS
system. The CONP is shown in the LCD of the calling party’s
station.
OFF
ON
OFF
Net Signal
Method
Network signaling can be sent in the Facility or User QSIG
supplementary service message.
UUS/
Facility
Facility
Net Cas Enable
Not used.
OFF
ON
OFF
Net VPN Enable
Not used.
OFF
ON
OFF
Net CC Retain
Mode
This field defines the Network signaling retain mode for CCBS
service.
OFF
ON
OFF
Net IP Auth.
For operation, the Networking function must be enabled here.
Note a license is required.
OFF
ON
OFF