iPECS UCP100 - CO;IP Group Access - PGM 117

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
78
4.4.2.7 CO/IP Group Access - PGM 117
Selecting CO/IP Group Access will display the CO/IP Group Access data input page. Enter a valid station
range and click [Load] to enter CO/IP Group Access data. Check the appropriate boxes to allow or delete
access to each CO/IP Group. Click the [Save] button after changing Value to apply.
Figure 4.4.2.7-1 CO/IP Group Access
Stations can be allowed or denied access to CO Lines and IP Channels by group (eMG80/100: 20 &
eMG800/UCP: 200). As a default, all stations are allowed access to all groups except Private Lines (group 00)
and unused CO Lines. The CO Line is assigned as a Private Line by default.